1. Introduction to solar power system:
Solar panel (receive solar energy to charge battery) + Inverter (convert 12V DC from battery to 220V or 110V AC) + Solar controller (control battery charging and discharging) + Battery (energy storage) (provided by customer).
2.Solar Panel 600W
Power: 18V± 5%
Size: 560x420x3mm
DC IN/OUT output: 18V/2.8A
USB output 1: 5V/2.4A
USB output 2: 5V/2.4A
Power under normal condition: 20W-80W
Irradiance = 1000W/㎡
Weight: 0.8kg
Packing weight: 0.9kg
Packing size: 445x300x41mm
Type: Mono Folding Solar Panel
Material: Aluminum substrate+effcient chip+PET
3.Power Inverter 6000W:
Input voltage: DC 10.5V~15V,
(When the battery voltage is lower than 10.5V, the inverter is low voltage protection, when the battery voltage is higher than 15V, the inverter high voltage protection)
Output voltage : AC 220V/110V
Input voltage: 12VDC
Output frequency is: 50Hz/60Hz
Dual USB interface: 5VDC/2.1A
Digital Display: Input/Output Voltage
Peaks Power : 6000W
Rated power:500W(Please make sure that the total rated power of the connected devices is ≤ 500W).
Output waveform: Modified sine wave
Product Size for inverter: 205x117x58mm
Packaging:
Individually packed: solar panel + inverter + 100A controller.
What’s in the box:
1pc inverter + 1 pair of red and black battery clips + 1pc cigarette lighter + English manual for inverter + 1pc solar controller + English manual for controller + solar panel + DC cable + DC alligator clips.
Friendly reminder：
1. Please try to use our standard battery cable, otherwise it will not output maximum power.
2. Start the inverter; start the machine first, then switch on the load. Switch off the machine: disconnect the load first, then switch off.
3. It is strictly forbidden to connect the mains power to the output port, and to connect the battery to the load inversely.
4. Do not overload electrical appliances such as inverters, motors, pumps, air conditioners and other inductive loads. Multiply the rated power by at least three times and the resulting value shall not exceed the power of the inverter.
5. The inverter red light comes on and hums. Check that the inverter is not overloaded and that the batteries are fully charged (whether they are new or not). Charge the batteries for at least 3 hours and try again.
6. Switch the inverter off when not in use.
When the inverter beeps, be sure to disconnect the load and turn off the power switch before turning off the inverter.
Note:
1. Please allow 0‑1 inch error due to manual measurement. Thanks for your understanding.
2. Monitors are not calibrated same, item color displayed in photos may be showing slightly different from the real object. Please take the real one as standard.
3. This product does not have power storage function.
